Festo Контроллер крайних положений SPC11 - Manual (Page 22)

1. Summary of components
1−10
Festo P.BE−SPC11−DSMI−EN en 0910b
Rotary drive type DSMI−... ( 6Ă)
Please note
Please observe the notes in the operating instructions for
the DSMI−...−... . Make sure that:
Ĉ the permitted transverse force
Ĉ the permitted longitudinal force
Ĉ and the maximum permitted swivel frequencies are
observed.
The end position cushioning is regulated electronically. In conĆ
junction with the SPC11 special mass moments of inertia thereĆ
fore apply (see Parameters for the DSMI−..." in chapter 2).
Please note
Make sure that the permitted mass moment of inertia is
observed.
Please note
Make sure that a cushioning plate is not fitted on the stop
lever.
During commissioning or when operated with a cushioning
plate fitted, error E03 may occur.
S Use a DSMI−... with integrated fixed stop.
S Where applicable, remove the cushioning plate from the
stop lever of the DSMI−... .
S Fit the rotary drive horizontally. In this case the drive shaft
is positioned either vertically upwards or downwards.