Festo Контроллер крайних положений SPC11 - Manual (Page 15)

1. Summary of components
1−3
Festo P.BE−SPC11−DSMI−EN en 0910b
1.1 General instructions
Warning
Faults in the system structure and incorrect parameter
settings can cause the slide to move to an end position
uncushioned. The fixed stop or the rotary drive may then
be damaged. You must observe the following instructions
in order to prevent such damage.
S Pay special attention to the design of the system. Always
observe the safety instructions and information in this
manual as well as in the system manual for type P.BE−
SPC11−SYS... .
S Use only the special matching components from Festo for
setting up and wiring the system. Only in this way can you
guarantee the correct functioning of the system.