Festo Стандартные цилиндры DNC-V с распределителем - Manual (Page 15)

Pneumatic linear cylinder
Festo 0506a English
15
S Use the same medium composition
throughout the service life of the product.
Example:
selected: non−lubricated compressed air
continue to use: non−lubricated comĆ
pressed air.
S Slowly pressurize the complete system.
This will prevent uncontrolled movements
from occurring.
4 Installation
Mechanical installation
S Check whether the type designation of the cylinder to be fitted is the same as
that of the desired cylinder.
S Handle the cylinder with care so that the
cylinder barrel and the piston rod are not
damaged.
This would reduce operational reliability
and the service life.
S Place the cylinder on the support so that
the adjusting screws for the end position
cushioning are always accessible.
S Make sure that:
ć external guides, if used, are fitted
parallel,
ć they are not distorted and
ć the maximum permitted loadings as
per catalogue are not exceeded.
S Observe the maximum tightening torques specified in the catalogue for
screws, locking nuts or accessories.
Fig. 3
Fig. 4
Fig. 5
Fig. 6