Muxlab HDMI 1x4 Distribution Hub - Manual (Page 12)

© MuxLab Inc. HDMI 1x4 Distribution Hub Installation Guide
Page 12
Ring, Tip to Tip), and that the two HDMI twisted
pair links are not crossed.
6. Using an HDMI cable (not supplied), connect an
HDMI/IR Receiver Balun (500407) to each HDMI
display.
7. Complete the connection between the Hub and each
HDMI display using standard straight-thru Cat 5e/6
UTP/STP cables and connecting hardware,
terminated on RJ45 plugs at both ends. Ensure that
there are no split pairs or taps.
8. Select the desired EDID setting using the rotary dial.
9. Power up the Baluns and HDMI equipment first.
10. Connect the external 12VDC power supply to the
Hub and plug the power supply into an AC power
outlet. If power is present, the blue power LED will
be ON.
11. Ensure that the source and appropriate display LEDs
are ON. Images should appear on the displays within
10 seconds. Check the image quality and refer to the
troubleshooting table in Section 4 if image quality is
unsatisfactory.
12. The following diagrams show some typical
configurations: