Muxlab Stereo AV/IR Pass-Thru Wall Balun, US - Manual

© MuxLab Inc. 2010 94-000678-A SE-000678-A
8495 Dalton Road, Mount Royal, Quebec, Canada. H4T 1V5
Tel: (514) 905-0588 Fax: (514) 905-0589
Toll Free (North America): (877) 689-5228
E-mail: [email protected] URL: www.muxlab.com
Specifications
Environment Composite video (NTSC, PAL, SECAM). Line level analog audio. IR Remote.
Devices DVD players, VCR, satellite receivers, MPEG players, laptops, notebooks,
monitors, LCD projectors, CCD cameras, video switchers, sequencers, digital
video servers, video multiplexers, video splitters, video converters and other
composite video equipment.
Transmission Transparent to the user
Composite Video Audio
Bandwidth DC to 6 MHz 20 Hz to 20 KHz over the
distance range
Impedance 75 ohms 600 ohms min.
Max. Input 1.1 Vp-p 1.1 Vp-p
Insertion Loss Less than 2 dB per pair over the frequency
range from DC to 6 MHz Less than 2 dB per pair over the
frequency range
Return Loss Better than 15 dB over the frequency range N/A
Common Mode
Rejection Ratio Greater than 40 dB over the frequency range N/A
Max. Distance via
Cat 5E/6
UTP/STP Cable 2,200 ft (670 m)
IR: Please refer to IR vendor specifications 3,250 ft (990 m)
Pin Configuration
(RJ45) Video: Pins 7(R) & 8(T)
IR Pass-Thru: Pins 4(R) & 5(T)
Reverse Polarity Sensitive Audio 1: Pins 1(R) & 2(T)
Audio 2: Pins 3(R) & 6(T)
Cable:
Cat 5E/6
UTP/STP 24 AWG or lower solid copper twisted pair wire
Impedance: 100 ohms at 1 MHz
Maximum capacitance: 20 pf/ft
Attenuation: 6.6 dB/1,000 ft at 1 MHz
Connectors Three RCA-F connectors: Video (yellow) & stereo audio (red, white)
One (1) 2-pole terminal block for IR emitter pass-through
One (1) RJ45 for Cat 5E/6
Temperature Operating: 0º to 55ºC
Storage: -20º to 85ºC
Humidity: Up to 95% non-condensing
Enclosure ABS fire retardant plastic, Color white, Finish glossy.
Dimensions 4.1” (104 mm) x 1.8” (45.7 mm) x 1.44” (36.6 mm). Choose 1.6” (40 mm)
deep back box to allow for Cat 5E/6 wiring connection.
Weight 4.1 oz (115 g)
Compliance FCC, CE, Decora® faceplate.
Warranty Lifetime
Order
Information 500049-WP-US Stereo AV/IR Pass-Thru Wall Balun
UPC: 6-27699-92049-7
Stereo AV / IR Pass-Thru Wall Balun
500049-WP-US
Quick Installation Guide
Overview
The Stereo AV/IR Pass-Thru Wall Balun (500049-WP-US) allows one (1) composite video,
one (1) stereo audio and one (1) IR emitter signal to be transmitted via a single Cat 5E/6
cable in a point-to-point connection. Used in pairs, or in conjunction with the 500048 or
500049, the Stereo AV/IR Pass-Thru Wall Balun features full audio bandwidth response for
high fidelity applications and features built-in color-coded RCA connectors for ease of
installation. The Stereo AV/IR Pass-Thru Wall Balun also works in conjunction with third
party IR Remote Control equipment. This enables the IR Emitter to connect to the IR control
module using the same Cat 5E/6 cable as video and audio, allowing for more cost-efficient
cabling. Some applications include: Classroom video distribution, commercial and home
audio/video systems, hospital video training, video conferencing, and video kiosks.
Installation
One (1) pair of baluns is needed to complete one composite stereo audio-video connection
via Cat 5E/6 twisted pair. To install the baluns, perform the following steps:
1. Identify the pin configuration of the baluns. One (1) twisted
pair is required for composite video and two (2) twisted pairs
are required for stereo analog audio. The pin configuration
follows the EIA/TIA 568A/B standard. The Stereo Hi-Fi
Video Balun is reverse polarity sensitive. Please ensure that
wiring is straight-through (Ring to Ring, Tip to Tip).