Muxlab HDMI 1x4 Distribution Hub - Manual (Page 11)

© MuxLab Inc. HDMI 1x4 Distribution Hub Installation Guide
Page 11
3.5. Installation Procedure
In order to install the product, please follow the steps
below:
1. Place the HDMI 1x4 Distribution Hub in its final
location.
2. Ensure that the power is turned off on the HDMI
source and displays.
3. In order to distribute the HDMI, one (1) HDMI/IR
Receiver Balun (500407) must be connected at each
HDMI display. To install the Baluns, complete Steps
4, 5, and 6.
4. Identify the pin configuration of the Baluns. Two (2)
Cat 5e/6 UTP/STP cables are required for each
HDMI connection. The pin configuration follows the
EIA/TIA 568A/B standard. The HDMI/IR Receiver
Balun is reverse-polarity sensitive. Please ensure
that the wiring is straight-through (Ring to Ring, Tip
to Tip), and that the two HDMI twisted pair links are
not crossed.
5. Using an HDMI cable (not supplied), plug the
HDMI source to the HDMI input of the HDMI 1x4
Distribution Hub. If the Cat 5e/6 input is used, one
(1) HDMI/IR Transmitter Balun (500406) must be
connected to the HDMI source, and two (2) Cat 5e/6
UTP/STP cables are required. The HDMI/IR
Transmitter Balun is reverse-polarity sensitive.
Please ensure that wiring is straight-through (Ring to