Muxlab Active VGA Managed System - Manual (Page 16)

© MuxLab Inc. Active VGA Managed Dispatcher Installation Guide
Page 16
Hub, please refer to MuxLab’s Active VGA Managed
Repeater Hub Installation Guide.
7. Power up the Receivers and local displays.
8. Connect the external 12VDC power supply to the
Dispatcher and plug the power supply into an AC
power outlet. If power is available, the power LED
will be ON.
9. Ensure that the source and appropriate displays are
on. Images should appear on the displays. Check the
image quality and refer to the troubleshooting table
in Section 4 if image quality is unsatisfactory.
10. Figures 5 and 6 show some typical configurations:
Figure 5: Simple Dispatcher/Receiver Configuration