Muxlab Active VGA Managed System - Manual (Page 15)

© MuxLab Inc. Active VGA Managed Dispatcher Installation Guide
Page 15
3.5. Installation Procedure
In order to install the product, please follow the steps
below:
1. Place the Active VGA Managed Dispatcher in its
final location.
2. Connect the source to the Dispatcher via the RS232,
Audio, VGA ports located on the back panel (Local
In). Ensure that the power is turned OFF at the
source. NOTE: Do not connect the power supply to
the Dispatcher at this point.
3. Optional: Connect a local display to the Dispatcher
via the RS232, Audio, VGA ports located on the
back panel (Local Out).
4. In order to distribute the VGA source to remote
displays, each remote display must be connected to
one (1) Active Managed Receiver (500174). To
install a Receiver, please refer to MuxLab’s Active
VGA Managed Receiver Installation Guide.
5. Complete the connection between the Dispatcher
and each remote display using standard straight-thru
Cat 5e/6 UTP/STP cables and connecting hardware,
terminated on RJ45 plugs at both ends. Ensure that
there are no split pairs or taps.
6. Optional: MuxLab’s Active VGA Managed Repeater
Hub (500172) may be connected to the Dispatcher to
increase the distance of remote displays by up to an
additional 1,000 ft (305 m). For installing a Repeater