Muxlab Active VGA Audio Balun Kit - Manual (Page 14)

© MuxLab Inc. Active VGA/Audio Balun Kit Installation Guide
Page 14
12. Connect the UTP cable to the Video IN/UTP
connector of the receiver.
13. Connect the second 12 VDC power supply to the
receiver.
14. Plug the power supply into an AC power outlet. If
power is present, the green power LED will be ON.
15. The brightness rotary switch adjusts the luminance
level to compensate for low frequency signal loss
due to the Cat 5e/6 cable.
16. The sharpness potentiometer adjusts the equalization
to compensate for high frequency signal loss due to
the Cat 5e/6 cable.
17. The skew (R G B potentiometers) adjust the delay
between the red, green, and blue colors to
compensate for the delay differences due to the Cat
5e/6 cable.
18. To adjust the picture quality, rotate the brightness
rotary switch and/or sharpness and/or skew
potentiometers on the rear panel of the Active
VGA/Audio Balun receiver. The factory default
position for the brightness (“Bright”) is “None,” and
the factory default position for the sharpness
(“Sharp”) and skew (R G B) is zero (rotated
completely counterclockwise).
Figure 5: Brightness and Sharpness Adjustment