SawStop ICS73600 - Manual (Page 9)

SawStop 10” Industrial Cabinet Saw 7
11. Wear proper apparel when using the saw. Do not wear loose clothing, gloves, neckties, rings, bracelets, or
other jewelry which may get caught in moving parts. Non-slip footwear is recommended. Wear a protective hair
covering to contain long hair.
12. Always wear safety glasses when using the saw. Also use a face or dust mask if the cutting operation is dusty.
Everyday eyeglasses are not safety glasses.
13. Keep hands out of the line of the saw blade. Never reach around or over the saw blade. Keep proper footing
and balance at all times.
14. Maintain the saw as specified in this manual. Use only identical replacement parts when servicing the saw.
15. Turn the power disconnect switch to OFF before servicing the saw and when changing components or
accessories such as blades, brake cartridges, and the like.
16. Use only recommended accessories with the saw. Consult this manual for recommended accessories. The use
of improper accessories may cause risk of injury to persons.
17. Never stand on the saw. Serious injury could occur if the saw is tipped or if the cutting tool is unintentionally
contacted.
18. Check to make sure the saw is in proper working order before using the saw. For example, check the alignment
of moving parts, look to see whether moving parts are binding or rubbing, check to see whether parts are broken,
make sure accessories are properly mounted in the saw, and check any other conditions that may affect the
operation of the saw. A guard or other part that is damaged should be properly repaired or replaced.
19. Feed work into the blade or cutter against the direction of rotation of the blade or cutter only. Feeding the work
in the direction of rotation may cause the work to be thrown by the blade and could result in serious personal
injury.
20. Never leave the saw running unattended. Wait until the blade comes to a complete stop, and then turn both the
Main Power switch and the Disconnect switch to OFF when you are finished using the saw.
21. You must install a rip fence before using this saw. Attempting to use the saw without a rip fence could result in
a serious personal injury.
22. Always maintain firm control over the material being cut. Never cut any material freehand.
23. Never operate the saw with the access doors open. Do not attempt to bypass or defeat the access door
interlock switches.
24. Secure your work. Use clamps or a vise to hold work when practical. It’s safer than using your hand and it frees
both hands to operate the saw.
25. Do not perform any operation freehand. Freehand means not using a fence (for rip cuts) or a miter gauge (for
cross-cuts) to guide the work piece as it is being cut. Always maintain firm control over the material being cut.
WARNINGS
!