SawStop ICS73600 - Manual (Page 64)

62 SawStop 10” Industrial Cabinet Saw
Making Adjustments to Your Saw
To set the height of the insert, use the included 3 mm hex L-wrench to adjust the front and rear leveling screws
until the insert is just below the surface of the table. The lower end of each front leveling screw should rest
on the corresponding support ledge on the table (see Fig. 76). When the lock-down lever is in the down and
locked position, latching arms extend under each of the support ledges to prevent the insert from rising up.
Adjusting the Rear Lock-Down Screws
The rear of the table insert is held down by a pair of lock-down screws mounted in the table at the rear of the
table opening. As shown in Fig. 77, the lock-down screw heads overlap the heads of the rear leveling screws
extending down from the insert. The overlapping screw heads prevent the rear of the insert from rising up.
The height of the lock-down screws
should be adjusted to fit close above
the leveling screws, while allowing
enough clearance to install and remove
the table insert without difficulty. The
height of the lock-down screws can be
adjusted using the included 3 mm hex
L-wrench.
Fig. 77
table lockdown
screws
Fig. 76
front leveling
screws
support ledge support ledge
rear leveling
screw
rear leveling
screw
latching arm latching arm