Making adjustments to your saw, Adjusting your saw – SawStop ICS73600 User Manual
Page 63
SawStop 10” Industrial Cabinet Saw 61
Adjusting
Your Saw
Making Adjustments to Your Saw
The head of the bolt is painted yellow for easy
identification. To adjust the position of the 45° limit
bolt, first loosen the locking nut and back it off
several turns. Next, turn the 45° limit bolt clockwise
to increase the angle of the limit stop, or counter-
clockwise to decrease the angle of the limit stop.
Now turn the tilt hand wheel clockwise until the
limit stop is reached. Recheck the angle of the
blade relative to the table. If further adjustment is
needed, decrease the tilt angle to about 30° and
readjust the 45° limit bolt. Repeat this process until
the blade is at 45° to the table when the limit stop
is engaged.
Once the 45° limit bolt is properly adjusted, turn
the locking nut clockwise until it is tight. The 45°
limit stop has now been set.
6. Adjusting the Table Insert:
The SawStop zero clearance insert has been designed to fit securely within the table opening and just below
the table top. The insert is pre-cut at the factory with a 10 inch blade after all alignments to the saw have been
completed.
As shown in Fig. 75, the insert includes front and rear leveling screws to set the height of the insert. In addition,
positioning screws at the rear and right side of the insert prevent it from rattling in the table opening. Finally, a
lock-down lever at the front of the insert prevents the insert from rising up unexpectedly.
The insert should slide easily into
and out of the table opening, but
should not be loose in the opening. If
the insert is too loose, use the 3 mm
hex L-wrench to turn the side and/or
front positioning screw(s) counter-
clockwise as needed to reduce the
clearance between the insert and the
table opening. If the insert is too tight,
turn the side and/or front positioning
screw(s) clockwise as needed to
increase the clearance between the
insert and the table opening.
Fig. 74
Fig. 75
45° tilt
limit stop
front leveling
screws
rear leveling
screws
positioning
screws
lock-down
lever