RMS Technologies R101 DRIVER/INDEXER - Manual (Page 23)

RMS Technologies Page 23 Version 1.31
R101 Single Axis Driver/Indexer Manual 10/1/2007
LD
Load Defaults
Command Only
Loads all of the unit Default parameter values. A save Data (SD) command must be
issued to have these values retained during a power cycle.
Command Example
#ALD Loads all default values.
Default values are:
My
Address 65 (A)
Absolute Position 0
Step Resolution 8
Run Current 10 (1.0A)
Hold Current 3 (0.3A)
Hold Timeout 5,000
Velocity Limit 15,000
Minimum Velocity 250
Start Velocity 1,000