Goulds Pumps AF (Axial Flow) (42"/1200mm/54/60"/66") LM/LMR Bearings - IOM" - Manual (Page 5)

AF (42-66) IOM 5
ATEX Identification
For a pumping unit (pump, seal, coupling, motor and pump accessories) to be certified for use in an ATEX classified
environment, the proper ATEX identification must be present. The ATEX tag will be secured to the pump or the
baseplate on which it is mounted. A typical tag will look like this:
II 2 G/D X
The CE and the Ex designate the ATEX compliance. The code directly below these symbols reads as follows:
II ------------  Group 2
2 -------------  Category 2
G/D ------------  Gas and Dust present
X ------------ Temperature class, can be T1 to T6 (see following table)
Maximum Process Temperature to achieve desired T rating
T Rating per EN 1127-1 Maximum Surface
Temperature in Celsius
Maximum Process
Temperature in Celsius
T1
450 410
T2
300 260
T3
20 0 165
T4
135 100
T5
100 65
T6
85 50
The code classification marked on the equipment should be in accordance with the specified area where the
equipment will be installed. If it is not, please contact your ITT/Goulds representative before proceeding.
Intended Use
The ATEX conformance is only applicable when the pump unit is operated within its intended use. All instructions
within this manual must be followed at all times. Operating, installing or maintaining the pump unit in any way that is
not covered in this manual can cause serious personal injury or damage to the equipment. This includes any
modification to the equipment or use of parts not provided by ITT/Goulds. If there is any question regarding the
intended use of the equipment please contact an ITT/Goulds representative before proceeding.