Balboa Water Group VGB 2008 211 GPM Suction Flow - Manual (Page 2)

Step One
Do not locate suction outlets on seating areas
or on the brackets for such areas.
Step Two
Cut a 3.5 ” hole into the spa wall for a flat gasket.
Cut a 3.63 ” hole into the spa wall for a L gasket.
Step Four
Place gasket on wall fitting
Step Five
Place wall fitting through the hole
Step Nine
Tighten nut securely
Step Ten
Glue adaptor into wall fitting
socket with 0.75” smooth barb or
0.5” socket facing up
Step Eleven
Attach schedule 40 plumbing to the
2.0” or 2.50” adaptor
Step Twelve
A tubing resistant to kink or
pinching shall be used
(or provided) for use with the
suction adaptor. Attach the
provided tubing 0.75” to the
smooth barb on the adaptor
fitting with glue and a clamp
to secure.
Step Six
Orient the tab down / Note
wording “INSTALL ARROW UP.”
Step Three
Back face the backside of the wall as
necessary so that it is parallel to the
front side of the wall.
Step Eight
Thread nut onto the wall fitting
Step Seven
Place the compensating ring on the
wall fitting with the flat side against
the wall.
Step Thirteen
Run 0.75” vinyl tubing above the
highest possible water level,
creating a Hartford loop, and
attach securely.
Step Fourteen
Place suction cover on wall fitting
with blank portion (no holes)
pointed down. The keyway
on inside cover must match with
tab on wall fitting.
Step Fifteen
Insert stainless steel screw in
cover and tighten securely.
(Do not over-tighten plastic
will strip).
VGB 2008
211 GPM Suction Flow
Installation Instructions
40747 Rev A May 21, 2012 Patented under U.S. Patent No. 8,191,183. ©2012 Balboa Water Group. All rights reserved.