Balboa Water Group spaTouch Menu Panel - Manual (Page 27)

42256_A 01-09-14 27
Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417,834 b2,
Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.
Basic Installation and
Configuration Guidelines
Use minimum 6AWG copper conductors only.
Torque field connections between 21 and 23 in lbs.
Readily accessible disconnecting means to be provided at time of instal-
lation.
Permanently connected power supply.
Connect only to a circuit protected by a Class A Ground Fault Circuit Inter-
rupter (GFCI) or Residual Current Device (RCD) mounted at least 5’ (1.52M)
from the inside walls of the spa/hot tub and in line of sight from the
equipment compartment.
CSA enclosure: Type 2
Refer to Wiring Diagram inside the cover of the control enclosure.
Refer to Installation and Safety Instructions provided by the spa manufac-
turer.
Warning: People with infectious diseases should not use a spa or hot
tub.
Warning: To avoid injury, exercise care when entering or exiting the spa
or hot tub.
Warning: Do not use a spa or hot tub immediately following strenuous
exercise.
Warning: Prolonged immersion in a spa or hot tub may be injurious to
your health.
Warning: Maintain water chemistry in accordance with the Manufactur-
ers instructions.
Warning: The equipment and controls shall be located not less than 1.5
meters horizontally from the spa or hot tub.
Warning! GFCI or RCD Protection.
The Owner should test and reset the GFCI or RCD on a
regular basis to verify its function.
CSA Compliance/Conformité
Caution:
s
s
s
s
s
s
s
Warning:
s
s
Attention:
s
s
s
s
s
s
s
Avertissement:
s
s
Warning/Advertissement:
s
s
Warning! Qualified Technician Required for Service and Installation
Warning! Shock Hazard!
No User Serviceable Parts.
Do not attempt service of this control system. Contact your
dealer or service organization for assistance. Follow all
owner’s manual power connection instructions. Installation
must be performed by a licensed electrician and all ground-
ing connections must be properly installed.