Balboa Water Group Plug N' Click Heater On An Older Spa System - Manual

Remove Heater Straps & Install Plug N’ Click Heater
– Turn off power to the system.
– Using a Phillips screwdriver unscrew the
2 screws on top of the enclosure and open the cover.
– Locate the 2 sensors holder on the circuit board.
– Remove the 2 heater sensors by depressing the
clip and gently pulling on the wire to remove
each sensor cable.
– Use a 3/8” (9.5mm) nut drive to remove the
2 nuts on the circuit board holding the heater
copper straps to the system.
– Remove the 2 heater nuts with a 3/8” (9.5mm)
wrench.
– Remove heater from system.
PARTS AND TOOLS YOU NEED
– 3/8” (9.5mm) torque wrench
– 3/8” (9.5mm) open end wrench
– 3/8” (9.5mm) nut driver
– Flat-head and Phillips screwdriver
– Heater Adapter Cable (25696)
– Replacement Balboa Heater
– Nyogel 760G (36308) and a stick
– Loctite Glue
STEP 1 OPEN THE SYSTEM BOX
STEP 3 REMOVE THE 2 HEATER SENSORS
STEP 2 REMOVE NUTS ON CIRCUIT BOARD
STEP 4 REMOVE NUTS ON HEATER
WARNING!
Please contact an electrician or your local electrical company when
connecting any spa electrical components. DO NOT OPEN THE SPA
SYSTEM AND ATTEMPT TO CONNECT THE CABLE CONNECTORS
YOURSELF. The high electrical voltage will harm or kill you.
Balboa Heater
Nyogel 760G and a stick (36308)
Heater adapter cable (25696)
Loctite Glue