Balboa Water Group ML700 - Mach 3 Quick Reference Guide - Manual

EL/GL Series - Mach 3
Cool
Warm Time
Mode/Prog
Blower
Jets 2
Light
Jets 1
F2
TL
F1
PL
ML700 Quick Reference Guide
Initial Start-up
When your spa is first actuated, it will go into Priming mode
(after displaying some configuration information).
Please
see the M-7 Installation Instruction Manual for complete
instructions on Power-up and Pump Priming.
The Priming mode will last for up to 4 minutes and then the
spa will begin to heat and maintain the water temperature
in the Standard mode. You can exit Priming mode early by
pressing “Warm” or “Cool.”
Setting the Time
Once the spa has been properly connected the first time (every power
up on the EL1000 and some EL2000 systems), notice the “
” icon
appearing on the screen.
Press then
Select the hour by pressing
Press
to exit the time setting procedure and enter the
optional filter cycle programming. (Exits programming
on some EL1000 and some EL2000 systems.)
Time Time
Press
to exit programming.
Press to enter.
Select minutes by pressing
Mode/Prog Mode/Prog
Time Time
Mode/Prog Mode/Prog
Mode/Prog Mode/Prog
Or
(Each press changes
the time by 1 minute)
Warm Warm
Cool Cool
Or
(Each press changes
the time by 1 minute)
Warm Warm
Cool Cool
Time
When time hasn’t been programmed, the “ ” icon
flashes. (Time settings on EL1000 and some EL2000 systems
are not preserved in the event of power loss; time will have to
be reprogrammed upon each power up.)