Led messages led deﬁnition purge cycle – Balboa Water Group Stand Alone Quiet-Flo Blower - 4 Buttons User Manual

Page 2

LED Messages

LED Deﬁnition

Purge Cycle

A Purge Cycle removes standing water from the plumbing and dries the air

UÊ

delivery system. This helps maintain a sanitary plumbing system.
Once the bath control thinks you’re ﬁnished using the bath, it schedules a Purge

UÊ

Cycle. The Session Timer LED ﬂashes periodically to indicate that a Purge Cycle
will soon begin.
Certain actions may cancel the planned Purge Cycle. This is normal. Otherwise,

UÊ

after a number of minutes, the 2-minute Purge Cycle will begin. At that point, the
Session Timer LED will light continuously.
When the Purge Cycle ends, all equipment turns off and the Session Timer LED

UÊ

turns off.

Session Timer On
Tells you a device button has been pressed and a
Session Timer is running.

Water Level Detected
Tells you there is still water in the tub. (Sensor required.)

Error
Tells you that your system needs servicing.
(See System Error Detection.)

System Error Detection

If an error occurs in the bath system, the red ERROR LED will ﬂash.

UÊ

In addition, the three remaining LEDs stay lit in a speciﬁc on/off pattern that

UÊ

reveals a diagnostic code of the error. If this should occur, take note which of
the three lights are on or off. This information will help technical support in
diagnosing the error.

System Reset

Press and hold the two top buttons for 10 seconds to turn all equipment off.

UÊ

Continue to hold the two top buttons 10 seconds longer to restart the system.