Avaya ExpertNet Lite Assessment Tool ELAT - Manual (Page 10)

ExpertNet Lite Assessment Tool - User Guide
8
Step 2.1: Location to Start Network Discovery
Steps 2.1 and 2.2 will only display if you selected the Discover Topology option.
Discover Topology Select this option if you want the Controller to discover network
topology from scratch. Steps 2.1 and 2.2 in the Configuration Wizard
are enabled. You must have SNMP access to network routers to use
this option.
Use Existing Topology Select this option if you want the Controller to reuse the existing
topology file from a previous discovery.
No Topology Select this option if you do not want to (or cannot) discover network
paths. The Network Tests > Discover Ping Tests entry in the main
menu bar will be disabled, but you will still be able to add Ping tests
manually. You may want to consider this option if SNMP access to
network routers is not allowed.
Use default gateway Select this option if you want the Controller to use the default gateway
configured on the Controller PC to start network discovery from.
Use this hostname or
IP address
Select this option if you want the Controller to use a specified initial
gateway to start network discovery from.