Sony LF-B10 - Manual (Page 58)

Confi
guring
the
Loca
tionF
ree Pl
a
y
er
18
Notes
• Point the remote at the IR Receiver of the Base
Station from a distance of about 1 to 2 inches.
• Keep pressing the button until the screen
disappears. Take care not to move the remote
while pressing the button.
• If an error message appears, make sure that you
are correctly aiming the remote at the IR
Receiver of the Base Station.
• Avoid locations in direct sunlight or under
strong illumination when sending the remote
signal.
• If the Base Station does not receive the signal
from your remote control, try replacing the
battery cell of the remote control.
z Tip
Device specific buttons may help to search the
remote control data of your device better than
general buttons (such as the power button or play
button).
5
Select a remote from the list, and then click
[OK].
The list window closes.
6
Click [Power on/off] to check to see if the
selection is correct.
If the configuration is correct, each time you
click [Power on/off], you can turn on or off
your device. If it does not work, make sure
that the IR blaster is correctly placed in front
of the remote sensor of the connected video
device.
7
Click [OK].
Setting up the learning remote
If you cannot find your external device in the list,
you can create the remote control data by
following the instructions below.
3
Select [Custom remote] from the list of
manufactures.
4
Select one of the generic panels from the
type list.