Sony LF-B10 - Manual (Page 12)

Se
tup a
nd Con
n
ec
tions
12
If you want to connect your Base Station to your
wireless router wirelessly, set the wireless mode
of your Base Station to Client mode. You cannot
use the Base Station in Client mode as a Wireless
Access Point.
When you make settings for Client mode, you
need to connect your Base Station to your
wireless router via a LAN cable as a temporary
connection, which you will disconnect after
completing the settings.
Note
You need to use a computer installed with the supplied
LocationFree Player (LFA-PC20) to make settings for
Client mode.
1
Slide the wireless mode switch toward
“CLIENT” to change the wireless mode to
Client mode. (
1 page 6)
To connect your Base Station to a wireless
router wirelessly, you need to change the
wireless mode to Client mode.
2
Connect a LAN cable between the Base
Station and the router.
When you make settings for Client mode,
you need to connect your Base Station to
your wireless router via a LAN cable as a
temporary connection. Insert a connector of
the LAN cable to the LAN port on the rear of
the Base Station, and then insert the other
connector of the cable to a LAN port of your
router.
Note
If your connector has a potential for an
overvoltage problem, do not connect it to the
Base Station. Follow the instructions of this
Operating Instructions when connecting.
3
Connect the power cord to the Base Station.
Notes
• Use only the supplied AC power adapter.
• Do not bundle the cord of the AC power adapter and
the antenna cable together. It may degrade the TV
picture quality where the TV signal is weak.
4
Press the POWER button on the front panel
of the Base Station to turn it on.
Using the Base Station in
Client mode (LF-B20 only)
IR BLASTER
LAN
1 2
S VIDEO
IN 1
IN OUT
VIDEO
AUDIO
L
R
VIDEO
AUDIO
L
R
VIDEO
DC IN 12V
AUDIO
L
R
IN 2
OUT
LF-B20
AC power adapter
(supplied)
Base Station rear panel
Wall outlet
Power cord
(supplied)
To DC IN
Connect the power cord to the Base Station AC power
adapter, and the AC power adapter to the DC IN jack on
the Base Station, then plug the power cord into a wall
outlet.
WIRELESS
NETWORK
SETUP MODE
RESET
SETUP MODE/
NET AV