Agilent Technologies N-Series - Manual (Page 78)

Page 5-57 XTRAEDIT CONFIGURATION
Up to 64 values can be entered, in any order. Duplicate entries are
automatically reconciled, and XTRAEDIT will automatically place the
entries in their correct order.
Values can be entered in inches, 1/300 inches or 1/60 inches, depending
upon the setting of Measurement Setting for Entries under the
Preferences menu. If inches, the user can enter a value between 0.000
and 14.000. In 1/300 inches, the user can enter an integer value between
0 and 4200. In 1/60 inches, the user can enter an integer value between 0
and 840.
Delete tab settings by highlighting the value to be deleted, then press v or
x. After entering and/or deleting values, use the mouse or t to select OK,
or press d to accept the choices.
The following chart show the default portrait and landscape tabs stops: