Agilent Technologies N-Series - Manual (Page 36)

Page 4-15 XES COMMANDS
The “Font Delete” command is a job boundary command that deletes
specified fonts from those already downloaded, where fontname is the
name of the font entered exactly as it appears on the Configuration/Status
Page, and where each fontname is separated by a comma. This command
also deletes the current merge page from memory. Printer default or system
fonts cannot be deleted.
Font ID Assignment
▲ ▲ ▲ ▲ ▲
COMMAND: COMMAND: COMMAND: COMMAND: COMMAND:
s
+# +# +# +# +# fontname fontname fontname fontname fontname
d
▲ ▲ ▲ ▲ ▲
RANGE: RANGE: RANGE: RANGE: RANGE: 0-9 0-9 0-9 0-9 0-9
This command assigns an ID number to a font, where # is a numeral
between 0 and 9, and where fontname is the name of the font entered
exactly as it appears on the Configuration/Status Page. Once assigned, the
ID number is used to call up a font in storage. This is not a job boundary.
When the user implements this command, the assigned font (resident in
the XLi’s FLASH memory) is downloaded to the printer.
Font Change
▲ ▲ ▲ ▲ ▲
COMMAND: COMMAND: COMMAND: COMMAND: COMMAND:
s
# # # # #
▲ ▲ ▲ ▲ ▲
RANGE: RANGE: RANGE: RANGE: RANGE: 0-9 0-9 0-9 0-9 0-9
The “Change Font” command causes all subsequent data to be printed in
the new font until a “Reset” or another “Change Font” command is
received, where # is the ID of the font as assigned by the command “Font
ID Assignment.”
Page Formatting Commands
This section describes the commands that control page formatting,
including margins, tabs, line spacing and measurement units. Margins,
tabs and page size settings are dependent upon the unit of measurement
selected by the “Units” commands directly below.
Units — 1/60"
▲ ▲ ▲ ▲ ▲
COMMAND: COMMAND: COMMAND: COMMAND: COMMAND:
s
zg zg zg zg zg
▲ ▲ ▲ ▲ ▲
RANGE: RANGE: RANGE: RANGE: RANGE: N/A N/A N/A N/A N/A