Agilent Technologies N-Series - Manual (Page 39)

User’s Manual Page 4-18
Tabs Horizontal
▲ ▲ ▲ ▲ ▲
COMMAND: COMMAND: COMMAND: COMMAND: COMMAND:
s
t# t# t# t# t#
1 1 1 1 1
,# ,# ,# ,# ,#
2 2 2 2 2
,...# ,...# ,...# ,...# ,...#
64 64 64 64 64
d
▲ ▲ ▲ ▲ ▲
RANGE: RANGE: RANGE: RANGE: RANGE: See See See See See Margins Margins Margins Margins Margins command command command command command
This command sets the horizontal tabs, where #
n
is the value of the tab
expressed in 1/60" or 1/300" units. As many as 64 horizontal tab values
may be entered.
For example, using a 1/60" unit of measure, to set tab stops at 0.75", 3.0"
and 4.5", enter:
s
t45,180,270
d
The following list outlines the rules for setting horizontal tab stops:
▲
Default tab stops begin at 1.1" from the left side of
the page and are at every 0.44" thereafter.
▲
Tabs may be entered in any order.
▲
If more than 64 tab values are entered, the excess
tabs will be deleted, starting with the right most tab
value.
▲
The maximum tab position is 815 (13.58").
▲
Tabs are not effective beyond margins.
▲
If the page orientation is changed, the tab settings
must also be changed.
▲
Tab settings remain valid until the “Reset” or “Clear
Horizontal Tabs” commands are sent.
Tabs Clear Horizontal
▲
COMMAND: COMMAND: COMMAND: COMMAND: COMMAND:
s
d d d d d
▲
RANGE: RANGE: RANGE: RANGE: RANGE: N/A N/A N/A N/A N/A
This command clears all horizontal tab settings.