Line draw (x or y), Document enhancement commands, Bold start – Agilent Technologies N-Series User Manual
Page 46: Line draw (x or y) -22, Document enhancement commands -22, Bold start -22
Page
4-25
XES COMMANDS
Line Draw (X or Y)
▲
COMMAND:
COMMAND:
COMMAND:
COMMAND:
COMMAND:
s
x(or y)X,Y,L,W,S
x(or y)X,Y,L,W,S
x(or y)X,Y,L,W,S
x(or y)X,Y,L,W,S
x(or y)X,Y,L,W,S
d
▲
RANGE:
RANGE:
RANGE:
RANGE:
RANGE:
See Below
See Below
See Below
See Below
See Below
To draw a line parallel to the x (short edge) axis, enter:
s
xX,Y,L,W,S
d
To draw a line parallel to the y (long edge) axis, enter:
s
yX,Y,L,W,S
d
where X and Y specify the starting point of the line, where L is the length
of the line expressed in dots, where W is the width of the line expressed in
dots (with a value between 1 and 31), and where S is the line shading (any
value between 0 and 15 is accepted, where 15 is solid black).
For example, if the user would like to draw a line on a portrait orientation
page, parallel to the y axis, that starts 1.75" over from the x origin and
0.25" up from the y origin, and that is 6.0" long and 1/50" wide:
s
y525,75,1800,6
d
The page orientation is determined by the first font on the page, so be
certain to specify a font before using this command.
To draw a line on a landscape orientation page, parallel to the x axis, that
starts 5.0" down from the x origin and 1.5" over from the y origin, and that
is 4.0" long and 1/100" wide:
s
x1500,150,1200,3
d
Document Enhancement Commands
This section describes the commands for bolding, underlining,
overstriking, subscripting and superscripting text.
Bold Start
▲
COMMAND:
COMMAND:
COMMAND:
COMMAND:
COMMAND:
s
b
b
b
b
b
▲
RANGE:
RANGE:
RANGE:
RANGE:
RANGE:
N/A
N/A
N/A
N/A
N/A