Agilent Technologies N-Series - Manual (Page 27)

User’s Manual Page 4- 6
character.
It makes no difference to the XLi which emulation name follows
“EMULATE.” Any emulation except for the three below will cause the
XLi to enter pass-through mode. When the XLi receives one of the
following commands, it will change back to XES-to-PCL5 translation:
=MCK= EMULATE/2700/END
d
=MCK= EMULATE/XDCS/END
d
=MCK= EMULATE/XES/END
d
A space is required immediately after the command sequence =MCK=.
An emulation change is always temporary, and will revert back to the
default mode after a power off/on.
Note: Changing emulation modes may cause the printer to erase all
downloaded fonts from memory. In such cases, the user will need to
download the fonts to the printer after executing an emulation change.
Alternatively, the printer can be configured with context saving enabled.
The X/Li also supports the =MCK= commands “SAVE” and “RESTORE.”
The =MCK= command “NVRAM” results in no operation.
=MCK= SAVE/END
d
will save the current emulation (either PCL or pass-through) to the XLi’s
FLASH memory until the printer is powered off.
=MCK= RESTORE/END
d
will change the emulation to the emulation stored using the “SAVE”
command above.
=MCK= RESET/END
d
will change the emulation to the default power-on emulation.