Agilent Technologies N-Series - Manual (Page 13)

Page 2-13 INSTALLATION
INSTALLATION
General Information
This chapter provides information on physically attaching the AGILE X/
TRA XLi to your Xerox printer.
Prior to Installation
The following are needed before installing the X/TRA XLi
▲
A Xerox DocuPrint ® N17, N24, N32 or N40 Network Laser
Printer
▲
A Centronics IEEE 1284C-compliant parallel input cable
▲
A ream of paper (or similar solid, flat surface)
▲
A phillips-head screwdriver
▲
Additionally, the user or someone in the user’s
organization should be knowledgeable about the host
system.
Selecting a Location
Refer to the user’s manual for your particular N-series laser printer to ensure
that the printer is properly located.
Electrical Requirements
The X/TRA XLi requires 5 VDC at 500 mA provided by the printer’s power
source.
Users with any questions regarding the electrical service available at their
site should contact a qualified electrician.
Operating Environment
The X/TRA XLi operates best within the specified temperature and relative