Agilent Technologies N-Series - Manual (Page 32)

Page 4-11 XES COMMANDS
then Reset must be introduced as follows:
*+X
d
Miscellaneous Commands
Print Multiple Copies (Collated)
▲ ▲ ▲ ▲ ▲
COMMAND: COMMAND: COMMAND: COMMAND: COMMAND:
s
+C# +C# +C# +C# +C# ,optional comment ,optional comment ,optional comment ,optional comment ,optional comment
d
▲ ▲ ▲ ▲ ▲
RANGE: RANGE: RANGE: RANGE: RANGE: 132 Characters for optional comment 132 Characters for optional comment 132 Characters for optional comment 132 Characters for optional comment 132 Characters for optional comment
This command currently is interpreted by the X/TRA XLi as “Print
Multiple Copies, Non-Collated”.
Print Multiple Copies (Non-Collated)
▲ ▲ ▲ ▲ ▲
COMMAND: COMMAND: COMMAND: COMMAND: COMMAND:
s
+E# +E# +E# +E# +E# ,optional comment ,optional comment ,optional comment ,optional comment ,optional comment
d
▲ ▲ ▲ ▲ ▲
RANGE: RANGE: RANGE: RANGE: RANGE: 2-999 2-999 2-999 2-999 2-999
This command causes multiple copies of the document to be printed, where
# is the number of copies. The number of copies may not exceed 999; if a
numeral greater than 999 is entered, only one copy will be printed.
This command will cause a Configuration/Status Page to print if: 1) an
error occurs and the Configuration/Status Page switch is enabled, or 2) the
previous command included a comma. An optional comment of up to 132
characters, if entered, will be printed on the Configuration/Status Page.
Paper Tray
▲ ▲ ▲ ▲ ▲
COMMAND: COMMAND: COMMAND: COMMAND: COMMAND:
s
c# c# c# c# c#
d
▲ ▲ ▲ ▲ ▲
RANGE: RANGE: RANGE: RANGE: RANGE: 1-3 1-3 1-3 1-3 1-3
This command selects the paper source drawer, where # is the number of
the drawer (1 through A). The XLi does not support automatic tray
switching.