Pch 5120, 5 hard drive and compactflash replacement, 6 cover replacement – Acnodes PCH 5120 User Manual
Page 69
14628 Central Blvd,
Chino, CA91710
tel:909.597.7588, fax:909.597.1939
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at
PCH 5120
12.1” industrial Panel PC
IP67 rated fully enclosure
6.4 MEMORY MODULE REPLACEMENT
The flat panel PC has a preinstalled memory module. If the memory module fails, take the steps below
to replace it.
Step 1: Remove the back cover. See Section 6.3 above.
Step 2: Locate the memory module on the motherboard of the flat panel PC
Step 3: Remove the memory module by pulling both the spring retainer clips outward from the socket.
Step 4: Grasp the memory module by the edges and carefully pull it out of the socket.
Step 5: Install the new memory module by inserting it at an angle, then pushing down until the clips
snap into place (Figure 6-2).
6.5 HARD DRIVE AND COMPACTFLASH REPLACEMENT
To replace the hard drive or CompactFlash® card, please refer to the hard drive and CompactFlash®
installation sections.
6.6 Cover Replacement
To ensure that the PCH5120 remains water-tight, the instructions below must be followed exactly.
Step 6: Check the rubber seal is seated correctly.
WARNING:
The internal rubber seal must be correctly seated to stop water getting into the system. Not installing
the seal correctly can result in a short circuit and destroy the system.