Pch 512 0, 1 reset cmos, 2 at/atx power – Acnodes PCH 5120 User Manual

Page 18

14628 Central Blvd,

Chino, CA91710

tel:909.597.7588, fax:909.597.1939

please visit Acnodes’ web site at www.acnodes.com.

PCH 5120

12.1” industrial Panel PC

IP67 rated fully enclosure

Step 3: Replace the cover and fasten the screws.

Step 4: Make sure the outer seal is seated properly, then replace the cover.

3.4 JUMPER SETTINGS

NOTE:

A jumper is a metal bridge that is used to close an electrical circuit. It

consists of two metal pins and a small metal clip (often protected by a

plastic cover) that slides over the pins to connect them. To CLOSE/

SHORT a jumper means connecting the pins of the jumper with the

plastic clip and to OPEN a jumper means removing the plastic clip from a

jumper.

3.4.1 RESET CMOS

Jumper Label:

JP11

Jumper Type: 3-pin header

Jumper Settings:

See Table 3-1

This jumper will reset the CMOS. Turn off the system. Set the jumper to "Reset CMOS", turn on the power

for a few seconds. Turn off the system. Set the jumper back to "Normal".

3.4.2 AT/ATX POWER

Jumper Label:

JP10

Jumper Type: 2-pin header

Jumper Settings:

See Table 3-2