Karcher HKF 200 K2 - Manual (Page 35)

- 15
ƽ
Danger
Risk of injury and damage. Stop the lifting
unit after the working position has been
reached.

Pull the draw pipe upwards with the lift-
ing unit until the chain is almost com-
pletely tensioned. Now, the cleaning
heads are swivelled into the working
position on the inside of the tank.
ƽ
Danger
Risk of injury by escaping steam with leak-
ing containers. Therefore, close the lid of
the suction opening prior to operation.
Risk of explosion! The drive of the cleaning
heads must only be switched on while the
cleaning liquid is supplied at the same time.

Perform the cleaning process (the se-
quence of the cleaning process can
take place manually or via a site-sup-
plied controller).
 Lower the draw pipe by means of the
lifting unit.
 Tilt the spindle (i) of the transport safety
device into the recess fo the plate (k)
and tighten the star handle (h).
Note: The star handle (h) must be inserted
into the recess of the plate (k). This will pre-
vent inadvertent loosening of the transport
safety device.

Loosen the tensioning units on the T-
handle and slide them toward the out-
side to the edge of the baseplate.
 Lift the tank cleaning device out of the
tank using the lifting unit.
Protect the water-carrying parts of the plant
against frost because they can get totally
damaged. If the system is to be used during
frost conditions, it must be erected in a
frost-free location.
 Rinse the tank cleaning device for 30
seconds without adding detergents.
 Spray the tank cleaning device with a
high pressure cleaner.
Note: This will avoid crusting and adhesion
and thus a premature wear of the seals.
This will prevent exterior corrosion by ag-
gressive residual materials.
If a system is to be shut down during frost
conditions, it must be rinsed with a frost
protection solution. Frost protection solu-
tions generally protect from corrosion at the
same time.
Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.

When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
The basis for a safe operational plant is
regular maintenance.
Use only original parts of the manufacturer
or part suggessted by him, such as
– replacement and wear parts
– Accessory parts
– Fuel
– Detergent
ƽ
Danger
Risk of accident while working on the unit!
During all tasks:

Remove voltage from and secure high
pressure pump at the main switch.
 Shut off the cleaning liquid supply.
 Close the steam supply.
 Switch off the drive of the cleaning
heads and shut off the compressed air
supply.
 Operator
Work designated with the sign “Opera-
tor” may only be carried out by persons
who have been instructed in the safe
operation and maintenance on the high
pressure plant.
 Experts
Experts are individuals, who are, ac-
cording to their professional education,
able to install the equipment and to op-
erate the same.
 Customer Service
Work designated with the sign “Cus-
tomer Service” may only be done by the
fitters of Kärcher Customer Service.
In order to guarantee a reliable operation
og the equipment, we success, you signed
a maintenance agreement. Please refer to
you local Kärcher service department.
Cleaning
Extend the tank cleaning device
Frost protection
h
k
i
Shutting down
Shutdown
Storage
Transport
Maintenance and care
Who may perform maintenance?
Maintenance contract
35 EN