ROTHENBERGER ROPOWER 50 R - Manual (Page 23)

ENGLISH 19
1.3 Special safety instructions
Never put fingers, your face, hair or other parts of the body, or loose, wide items of clothing into
the operating and intake areas of rotating parts (workpiece, clamping chuck, centring chuck). Do
not wear jewellery (rings, chains etc.). Risk of injury and accidents!
In the event of faults (unusual smell, vibrations, unusual noises) during work with the ROPO-
WER 50R, it is essential to immediately press the safety pedal and perform an EMERGENCY
STOP of the machine!
If the machine is running, it is prohibited to hold the workpieces manually or to perform similar
work, and to fit and remove parts such as filters, valves, pipe sections etc!
Wear safety clothing! Wear a safety mask to provide protection against splashes of thread cut-
ting oil as well as any chlorine gas vapours (from thread cutting oil burning on hot tool and work-
piece surfaces)! Wear a safety hat to cover and protect long hair. Wear safety gloves when
changing the dies, the pipe cutting wheel and the pipe deburrer. Wear safety gloves when
changing the tool and workpiece. The thread and dies get hot during thread cutting! Wear safety
footwear. Risk of injury (slipping) on any escaping thread cutting oil! Risk of injury from wet, slip-
pery and possibly off-centre machine parts when changing the tool!
Do not remove metal chips using compressed air! There is a risk of eye injuries and loss of eye-
sight!
Ensure sufficient ventilation during indoor use (closed rooms). The permissible ambient temper-
ature is between 0°C and 40°C!
Before changing the die head, the cutting wheel, the pipe deburrer, always switch off the ma-
chine and pull out the mains plug (de-energized operation!)!
After it has been switched off, the machine still coasts for a while until it comes to a standstill.
Do not touch any parts before the machine is completely stationary and the mains plug has been
pulled out!
In the case of the threaded pipes, carry out a pressure test in order to ensure that no gas or wa-
ter can escape after the pipes are fitted!
2 Technical Data
Art.-No. 56050 ............................... ROPOWER 50 R, 230 V, BSPT R 1/4" – 2“
Art.-No. 56045 ............................... ROPOWER 50 R, 110 V, BSPT R 1/4" – 2“
Art.-No. 56057 ............................... ROPOWER 50 R, 230 V, BSPP R 1/4" – 2“
Speed ............................................ 40 rpm under no load
Motor ............................................. Single-phase universal motor 1150 W, overload protection
Protection class ............................. I
Protection type ............................... IP 34
Frequency ..................................... 50 / 60 Hz
Weight ........................................... ca. 68 kg
Dimensions .................................... 535 x 430 x 340 mm (LxWxH)
Die head ........................................ Automatic-die head 1/2“ – 2“ or 2 SE die heads
Dies ............................................... 1/2“ – 3/4“, 1“ – 2“ (Optional 1/4“ – 3/8“ Art.-No. 56369)
Vibration total ................................. < 2,5 m/s
2
Typical A-rated sound level:
Noise pressure level (L
pA
) .............. 85 dB (A) ¦ K
pA
3 dB (A)
Sound power level (L
WA
) ................ 96 dB (A) ¦ K
WA
3 dB (A)
The noise level during operation can exceed 85 dB (A). Wear hearing protection!
Measured values determined in accordance with EN 61029-1:2010.