Electrical installation requirements, Warning – Alliance Laundry Systems UW35AV User Manual

Page 27

Specifications and Dimensions

F232228

Electrical Installation Requirements

IMPORTANT: Electrical ratings are subject to
change. Refer to serial decal for electrical ratings
information specific to your machine.

Electrical connections are made at the rear of the
control module. The machine must be connected to the
proper electrical supply shown on the identification
plate attached to the side of the control module using
copper conductors only.

The AC inverter drive requires a clean power supply
free from voltage spikes and surges. A voltage monitor
should be used to check incoming power. The
customer’s local power company may provide such a
monitor.

IMPORTANT: Alliance Laundry Systems
warranty does not cover compounds that fail as a
result of improper input voltage.

If input voltage measures above 240 Volt for a
200 Volt drive or above 480 Volt for a 400 Volt drive,
ask the power company to lower the voltage. As an
alternative, a step-down transformer kit is available
from the distributor. Voltages above 250 Volt and
490 Volt require additional measures. Contact the
distributor or the manufacturer for assistance.

This machine must be installed, adjusted,
and serviced by qualified electrical
maintenance personnel familiar with the
construction and operation of this type of
machinery. They must also be familiar
with the potential hazards involved.
Failure to observe this warning may result
in personal injury and/or equipment
damage, and may void the warranty.

SW004

WARNING

Dangerous voltages are present in the
electrical control box(es) and at the motor
terminals. Only qualified personnel
familiar with electrical test procedures,
test equipment, and safety precautions
should attempt adjustments and
troubleshooting. Disconnect power from
the machine before removing the control
box cover, and before attempting any
service procedures.

SW005

WARNING

Ensure that a ground wire from a proven
earth ground is connected to the ground
lug near the input power block on this
machine. Without proper grounding,
personal injury from electric shock could
occur and machine malfunctions may be
evident.

SW008

WARNING