Swiftech H20 220 ULTIMA XT REV2 - Manual (Page 15)

Copyright Swiftech 2010 – All rights reserved – Last revision date: 4-27-10- Information subject to change without notice – URL: http://www.swiftech.com
Rouchon Industries, Inc., dba Swiftech – 151 West Victoria Street, Long Beach, CA 90803 – Tel. 310-763-0336 – Fax 310-763-7095 - E Mail: [email protected] 15 of 15
 Then, you will need to disconnect a line from one of the lowermost components. Typically, this would be the pump. You
need to procure a bucket large enough to receive approximately 1 liter of fluid, and place the bucket underneath the
connection that you intend to “break”. Disconnect the line, and place both ends into the bucket, until all the liquid is
drained from the system.
9. P ERIODIC M AINTENANCE
 Every 6 months: dust off the radiator fins and fan. You can use a can of compressed air for example, available
in most electronic supply stores. If you live in a very dusty area, you should perform this task at closer intervals.
It is essential to maintain the optimum performance of your cooling system.
 Inspect the liquid level inside the reservoir, and refill if necessary (no refills are normally necessary for 18
months of continuous usage). Evaporation in this closed circuit is extremely limited, but still present due to
some permeability in the vinyl lines.
10. O PTIONAL C OMPONENTS
Please visit our web site at www.swiftech.com on a regular basis, as we continuously release new products that could enhance the use
of your H20-220 Apex Ultima liquid cooling kit!
Thank you for trusting Swiftech® for your computer-cooling needs!