Allied Telesis AT-PBC18 User Manual
Page 47
PowerBlade PBC18 Quick Install Guide
37
! 11
Electrical - Type Class 1 Equipment This Equipment Must Be Earthed.
Power plug must be connected to a properly wired earth ground socket
outlet. An improperly wired socket outlet could place hazardous voltages on
accessible metal parts.
! 12
Pluggable Equipment, the socket outlet shall be installed near the
equipment and shall be easily accessible.
! 13
Caution: Air vents must not be blocked and must have free access to the
room ambient air for cooling.
! 14
Operating Temperature: This product is designed for a maximum
ambient temperature of 40° degrees C.
! 15
All Countries: Install product in accordance with local and National
Electrical Codes.
! 16
As a safety precaution, a 10 Amp circuit breaker should be installed at the
supply end of the cable to be used with this LAN equipment.
Always connect the wiring to the LAN equipment first before connecting
the wiring to the breaker. To avoid the danger of physical injury from
electrical shock, do not work with HOT feeds. Always be sure that the
breaker is in the OFF position before connecting the wiring to the breaker.
! 17
Warning: Do not strip more than the recommended amount of wire.
Stripping more than the recommended amount can create a safety hazard
by leaving exposed wire on the terminal block after installation.
! 18
When installing this equipment, always ensure that the frame ground
connection is installed first and disconnected last.
! 19
Caution: “Safety Hazard” Check to see if there are any exposed copper
strands coming from the installed wire. When this installation is done
correctly there should be no exposed copper wire strands extending from
the terminal block. Any exposed wiring can conduct harmful levels of
electricity to persons touching the wires.
! 20
This system will work with Positive grounded or Negative Grounded DC
systems.
! 21
Lithium Battery - Should only be changed by trained and qualified
technician.
Caution: Danger of explosion if battery incorrectly replaced. Replace only
with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer’s instructions.
Attention: Il y a danger d’explosion s’ily y a remplacement incorrect de la
batterie. Remplacer uniquement avec une batterie du même type ou d’un
type recommandé par le constructeur. Mettre au rébut les batteries usagés
conformement aux instructions du fabricant.