Allied Telesis AT-PBC18 - Manual (Page 15)

PowerBlade PBC18 Quick Install Guide
5
DC Power Supply
The DC power supply has a 48 V DC terminal block connector. Figure 4 shows
an PowerBlade PBC18 with a DC power supply.
Figure 4 PowerBlade PBC18 with a DC Power Supply
Optional Management Module
The management module is an optional module used to monitor the operating
status of the switches and media converters installed in the PowerBlade
PBC18. Refer to Figure 2 on page 2 for the location of the expansion slot. The
management module is not required for the chassis to operate, but it is
necessary if you want to locally or remotely monitor and configure the
modules and ports.
The management module features a Link, Power, and Status LED as well as a
Reset button. (See Figure 5) The LEDs and the Reset button are duplicated on
the front of the chassis for easy monitoring or to reset the management
module. You may need to reset the module after completing the installation,
adding or hot swapping a power supply, or after upgrading the module’s
firmware.
To install an optional management module, refer to “Installing an Optional
Management Module” on page 27.
Figure 5 Optional Management Module (AT-PBM02 Model)
PBM02
Management
MDI-X
MDI
LNK STATUS
PWR RESET
RS-232 T erminal 10B ase-T
PBM02
Management
MDI-X
MDI
LNK STATUS
PWR RESET
RS-232 T erminal
10Base-T