Allied Telesis AT-PBC18 - Manual (Page 33)

PowerBlade PBC18 Quick Install Guide
23
Installing a Main Power Supply
To install a main power supply, perform the following procedure:
1. Remove the PWR 1 blank faceplate from the back of the chassis by
loosening the two thumbscrews, as shown in Figure 17.
Figure 17 Removing the Main Power Supply Blank Faceplate
2. Remove the power supply for the shipping package and store the
packaging material in a safe location.
3. Slide the power supply into the slot, gently seating the power supply’s
connector into the chassis’ backplane. See Figure 18.
Figure 18 Installing the Main Power Supply
4. Secure the power supply to the chassis by tightening the two
thumbscrews.
5. Apply power to the module by connecting the AC power cord or DC wires.
Refer to page 11, Step 4 for an AC unit or Step 5 for a DC unit.
6. The power supply’s Power LED should be ON. If the LED is OFF, refer to
“Troubleshooting” on page 31 for instructions.
The PowerBlade PBC18 is now ready for use.
PBM02 Mana geme nt
MDI-X
MDI LNK STAT US PWR RESET RS-23 2 Ter minal
10Bas e-T
PBM02 Mana geme nt
MDI-X
MDI LNK STAT US PWR RESET RS-23 2 Ter minal
10Base -T