Allied Telesis AT-S63 - Manual (Page 481)

AT-S63 Management Software Menus Interface User’s Guide
Section VI: Virtual LANs 481
Example of Creating a Tagged VLAN
This procedure is an example of how to create a tagged VLAN. The
specifications of the example VLAN are:
Name: Engineering
VID: 3
Tagged ports: 2, 10
Untagged ports, 9, 11 to 13
To create the Engineering VLAN, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 163 on page 474.
2. From the VLAN Configuration menu, type 3 to select Configure
VLANs.
The Configure VLANs menu is shown in Figure 164 on page 475.
3. From the Configure VLANs menu, type 1 to select Create VLAN.
The Create VLAN menu is shown in Figure 165 on page 475.
4. From the Create VLAN menu, type 1 to select VLAN Name and enter
“Engineering”.
5. Type 2 to select VLAN ID (VID) and enter “3”. This is the VID value for
the new VLAN.
6. Type 3 to toggle VLAN Type to Port Based.
7. Type 4 to select Tagged Ports and enter “2,10”. These are the tagged
ports of the VLAN on the switch.
8. Type 5 to select Untagged Ports and enter “9,11-13”. These are the
untagged ports of the VLAN.
Note
Option 6, Protected Ports, must be left in the “No” default setting
when creating a port-based or tagged VLAN. This option is
explained in Chapter 26, “Protected Ports VLANs” on page 523.
9. Type C to select Create VLAN.
10. When you see the confirmation prompt, press any key.