Allied Telesis AT-S63 - Manual (Page 333)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: SNMPv3 333
6. Enter Y to delete the view or N to save the view.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying an
SNMPv3 View
Table Entry
This section describes how to modify parameters in an SNMPv3 Notify
Table entry. See the following procedures:
ˆ “Modifying a Subtree Mask” on page 333
ˆ “Modifying a View Type” on page 335
ˆ “Modifying a Storage Type” on page 336
Modifying a Subtree Mask
To modify the Subtree Mask parameter in an SNMPv3 View Table entry,
perform the following procedure.
1. Display the Configure SNMPv3 Table menu by performing steps 1
through 3 in “Configuring the SNMPv3 User Table” on page 319. Or,
from the Main Menu type 5->5->5.
The Configure SNMPv3 Table menu is shown in Figure 118 on page
320.
2. From the Configure SNMPv3 Table menu, type 3 to select Configure
SNMPv3 View Table.
The Configure SNMPv3 View Table menu is shown in Figure 121 on
page 330.
3. From the Configure SNMPv3 View Table menu, type 3 to select Modify
SNMPv3 Table Entry.