Allied Telesis AT-S63 - Manual (Page 374)

Chapter 20: SNMPv3
374 Section IV: SNMPv3
3. To delete an SNMPv3 Target Address Table entry, type 2 to select
Delete SNMPv3 Table Entry.
The following prompt is displayed:
Enter Target Address Name:
4. Enter a Target Address Name.
The following prompt is displayed:
Do you want to delete this table entry?(Y/N):[Yes/No]->
5. Enter Y to delete the SNMPv3 Target Address Table entry or N to save
the entry.
6. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying an
SNMPv3 Target
Address Table
Entry
This section describes how to modify parameters in an SNMPv3 Target
Address Table entry. See the following procedures:
ˆ “Modifying a Target IP Address” on page 374
ˆ “Modifying the Target Address UDP Port” on page 376
ˆ “Modifying the Target Address Timeout” on page 377
ˆ “Modifying the Target Address Retries” on page 378
ˆ “Modifying the Target Address Tag List” on page 379
ˆ “Modifying the Target Parameters Field” on page 380
ˆ “Modifying the Storage Type” on page 381
Note
You cannot modify the Target Address Name parameter.
Modifying a Target IP Address
To modify the target IP address in an SNMPv3 Target Address Table
entry, perform the following procedure.
1. Display the Configure SNMPv3 Table menu by performing steps 1
through 3 in “Configuring the SNMPv3 User Table” on page 319. Or,
from the Main Menu type 5->5->5.
The Configure SNMPv3 Table menu is shown in Figure 118 on page
320.
2. From the Configure SNMPv3 Table menu, type 7 to select Configure
SNMPv3 Target Address Table.