Allied Telesis AT-S63 - Manual (Page 329)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: SNMPv3 329
Configuring the SNMPv3 View Table
This section contains a description of the SNMPv3 View Table and how to
create, delete, and modify table entries. Creating this table, allows you to
specify a view using the following parameters:
ˆ Subtree OID
ˆ Subtree Mask
ˆ MIB OID Table View
To configure the SNMPv3 View Table, you need to be very familiar with
the OID table. You can be very specific about the view a user can or
cannot access—down to a column or row of the table. AT-S63 supports
the Internet subtree of the OID table.
There are three functions you can perform with the SNMPv3 User Table:
ˆ “Creating an SNMPv3 View Table Entry,” next
ˆ “Deleting an SNMPv3 View Table Entry” on page 332
ˆ “Modifying an SNMPv3 View Table Entry” on page 333
Creating an
SNMPv3 View
Table Entry
To create an entry in the SNMPv3 View Table, perform the following
procedure.
1. Display the Configure SNMPv3 Table menu by performing steps 1
through 3 in “Configuring the SNMPv3 User Table” on page 319. Or,
from the Main Menu type 5->5->5.
The Configure SNMPv3 Table menu is shown in Figure 118 on page
320.
2. From the Configure SNMPv3 Table menu, type 3 to select Configure
SNMPv3 View Table.