Allied Telesis AT-iMG646PX-ON - Manual (Page 72)

Chapter 5: Installing the Gateway Indoors
72 Section II: Indoor Installation
Required Tools and Supplies
The following tools and supplies are required to install the gateway:
Tools
Have the following tools on hand before you install the enclosure or
gateway:
ˆ Flat head and #2 Phillips screwdrivers
ˆ Wire cutters
ˆ Crimping tool
Additional
Supplies
You may also need the following supplies:
ˆ Silicone sealant
ˆ Electrical tape
ˆ Two UV-rated wire ties
ˆ Console cable (AT-RGCONSOLECABLE)
ˆ Power cable (AT-RG013-00)
ˆ Power supply (AT-iMG005G)
ˆ Fiber cleaning materials (see Appendix B, “Cleaning Fiber Optic
Connectors” on page 91)
ˆ Plywood mounting surface (see “Fastening the Plywood Mounting
Surface to a Wall and Preparing the Gateway” on page 74 for
specifications)
ˆ Accessory kit for indoor installation
You will need the following items to create a ground wire for the DC
terminal block:
ˆ One piece of #18 AWG stranded wire, 4-1/2 to 5 in. (114.3 - 127 mm)
long, green with a yellow stripe
ˆ A 16-22 AWG #10 ring lug with a green insulation jacket