Allied Telesis AT-PC2002/POE - Manual (Page 46)

Chapter 2: Installation
46
Installing the Media Converter on a Wall
To wall-mount the media converter:
1. Select a wall location for the unit.
2. Install the two wall anchors included with the bracket into the wall so
that they are level with each other and are spaced 64 mm (2.52 in)
apart.
3. Install the two Phillips flat-head screws into the wall anchors. The
screws should protrude from the wall approximately 5 mm (0.2 in.).
Note
Depending on the location you have chosen for the unit, you may
find it convenient to skip the next step, which mounts the unit on the
screws, and instead assemble the unit on a table first before
mounting it on the wall.
4. Place the two keyholes in the unit over the two wall screws and slide
the bracket down to secure the bracket on the screws.
Figure 7. Positioning the Media Converter on the Wall Screws
1364
100Bas e-FX 1000Ba se-X
CLAS S 1 LASE R PRO DUCT