Allied Telesis AT-GS950/48 - Manual (Page 39)

AT-GS950/48 Gigabit Ethernet WebSmart Switch Installation Guide
39
Installing the Switch in a Rack
To install the AT-GS950/48 Gigabit Ethernet Smart switch in a rack,
perform the following procedure:
Note
The rack mount screws are not provided.
1. If attached, remove the rubber feet using a flat-head screwdriver as
shown in Figure 1.
1. Removing Feet from Switch
2. Install a bracket on one side of the switch using a Phillips screwdriver
and four of the rack-mount screws included with the switch, as shown
in Figure 9
Caution
The brackets provided must be used to securely mount the switch
on the rack.