Allied Telesis x310 Series - Manual (Page 84)

Chapter 6: Cabling the Stacking Ports
84
Cabling Switches with AT-StackXS/1.0 Transceivers
To cable the switches of the stack with AT-StackXS/1.0 transceivers,
perform the following procedure:
Warning
A transceiver can be damaged by static electricity. Be sure to
observe all standard electrostatic discharge (ESD) precautions,
such as wearing an antistatic wrist strap, to avoid damaging the
device.
1. Remove the dust plug from the S1 slot on the top switch of the stack,
as shown in Figure 37.
Figure 37. Removing the Dust Plug from the S1 Slot
2. Remove the transceiver from its shipping container and store the
packaging material in a safe location.
3. Remove the dust cap from one end of the transceiver, as shown in
Figure 38 on page 85.