Allied Telesis IE200 Series - Manual (Page 33)

Chapter 1: Overview
AT-IE200 Series Installation Guide 33
SFP LEDs
The SFP LEDs are located to the right of the slots. Each slot has one LED that indicates the speed and link/
activity status of the SFP.
Table 6: Port LED Descriptions for the AT-IE200-6GP and AT-IE200-6FP Switches
LED Status Description
PoE Off Indicates one of the following:
 The port is not connected to a powered
device (PD).
 The PD is powered off.
 The port is disabled in the management
software.
 PoE is disabled on the port.
 The LEDs are turned off. To turn on the
LEDs, use the NO ECOFRIENDLY LED
command.
Solid green A PD is receiving power from the port.
Solid amber The switch has shut down PoE+ on the port
due to a fault condition.
Flashing amber The switch is detecting a PD on the port but is
not delivering power to it because the
maximum power budget has been reached
Link/Activity Off The port has not established a link with
another network device or the LEDs are
turned off. To turn on the LEDs, use the NO
ECOFRIENDLY LED command.
Solid green The port has established a 100 Mbps (AT-
IE200-6FP) or 1000 Mbps (AT-IE200-6GP) link
to a network device.
Flashing green The port is transmitting or receiving data at
100 Mbps (AT-IE200-6FP) or 1000 Mbps (AT-
IE200-6GP).
Solid amber The port has established a 10 Mbps (AT-IE200-
6FP) or 10/100 Mbps (AT-IE200-6GP) link to a
network device.
Flashing amber The port is transmitting or receiving data at 10
Mbps (AT-IE200-6FP) or 10/100 Mbps (AT-
IE200-6GP).