Allied Telesis IE200 Series - Manual (Page 15)

Chapter 1: Overview
AT-IE200 Series Installation Guide 15
 Single-port BiDi 1000Base-LX SFP transceivers
 1000Base-ZX SFP transceivers
 1000Base-T twisted pair transceivers
Note
SFP transceivers must be purchased separately. For a list of supported transceivers, contact your Allied
Telesis distributor or reseller.
Alarm Ports
The IE200 contains two alarm ports: One for alarm input and one for alarm output.
LEDs
The IE200 contains LEDs to report device status and link/activity port LEDs.
 Link/activity and duplex mode LEDs for the twisted pair ports on non-PoE switches
 Link/activity and PoE status LEDs for the twisted pair ports on PoE switches
 Link/activity LEDs for SFP slots
 Status LEDs for fault alarms and both power supplies
Installation Options
There are two installation options for the IE200:
 DIN rail standard EN 50022
 Wall mount
MAC Address Table
IE200 MAC address tables support:
 Storage capacity of 4,000 MAC address entries
 Automatic learning and aging
Management Software and Interfaces
The IE200 supports the following management software and interfaces:
 AlliedWare Plus management software
 Command line interface
 Web browser interface