Allied Telesis AT-GS950/10PS - Manual (Page 34)

Chapter 1: Overview
34
Reboot/Reset the
Switch
Use the following procedure to reboot the switch or reboot the switch and
reset the switch to its factory default settings with the eco-Friendly button:
Caution
This procedure causes the switch to reboot. The switch does not
forward network traffic during the reboot process. Some network
traffic may be lost.
1. To reset the switch, press the eco-Friendly button for 5 to 9 seconds.
Rebooting takes approximately 1 to 2 minutes before the switch comes
back on line and is ready to transmit Ethernet traffic again.
2. To reboot the switch and reset the switch to its factory default settings,
press the eco-Friendly button for more than 10 seconds.
This initiates a software reboot of the switch and resets all of the
configuration parameters of the switch to the factory default settings,
including the management IP address which reverts to 192.168.1.1. If
your browser is configured for another IP address, you must
reconfigure your browser and workstation before you can connect to
the switch again.
Note
In the management software, you can disable both the reboot and
factory default reset functions for the eco-Friendly button. For more
information, see “Management Software” on page 20 for a list of the
guides.