Samsung SC-D6040-AFS - Manual (Page 3)

ENGLISH
Notices and Safety Instructions
9. VENTILATION:
Slots and openings in the cabinet are provided for ventilation to ensure
reliable operation of the CAMCORDER and to protect it from
overheating. These openings must not be blocked or covered. Never
place your CAMCORDER on a bed, sofa, rug, or other similar surface:
on or near a radiator or heat register. This CAMCORDER should not be
placed in a built-in installation such as a bookcase or rack unless proper
ventilation is provided or the manufacturer s instructions have been
adhered to.
10. POWER SOURCES:
The CAMCORDER should be operated only from the type of power
source indicated on the label.
If you are not sure of the type of power supply at your home, consult your
appliance dealer or local power company.
A CAMCORDER is intended to be operated from battery power, or other
sources, refer to the operating instructions.
11. GROUNDING OR POLARIZATION:
This CAMCORDER may be equipped with either a polarized
2-wire AC line plug (a plug having one blade wider than the other)
or a 3-wire grounding type plug, a plug having a third (grounding)
pin.
If you are unable to insert the plug fully into the outlet, try reversing the
plug. If the plug still fails to fit, contact your electrician to replace your
outlet. Do not defeat the safety purpose of the polarized plug.
12. POWER-CORD PROTECTION:
Power-supply cords should be routed so that they are not likely to be
walked on or pinched by items placed upon or against them, playing
particular attention to cords or plugs, convenient receptacles, and the
point where they exit from the unit.
13. OUTDOOR ANTENNA GROUNDING:
If an outside antenna or cable system is connected to the CAMCORDER,
be sure the antenna or cable system is grounded to provide some
protection against voltage surges and built-up static charges, Section 810
of the National Electrical Code, ANSI/NFPA No. 70-1984, provides
information with respect to proper grounding of the mast and supporting
structure, grounding of the lead-in wire and supporting structure,
grounding of the mast and supporting structure, grounding of the lead-in
wire to an antenna discharge unit, size of grounding to conductors,
location of antenna-discharge unit, connection to grounding electrodes
and requirements for the grounding electrode.
See figure below.
ELECTRIC SERVICE
EQUIPMENT
GROUND
CLAMP
ANTENNA
LEAD IN WIRE
ANTENNA
DASCHARGE UNIT
(NEC SECTION 810-20)
GROUNDING CONDUCTORS
(NEC SECTION 810-21)
GROUND CLAMPS
POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H)
NEC NATIONAL ELECTRICAL CODE